Saltar a contenido principal
Fotos
Fotos
Consejos
Lo último en Houzz
Conversaciones
Estudios de Houzz
Inicia sesión
Houzz Logo Print
Ver conversaciones
Pools & Spas
ken_houghton41

Variable Speed pump wiring

Ken Houghton
hace 6 años

I would like to know how to wire a salt water chlorine generator to a Pentair variable speed pump, so the generator goes on when the pump goes on.

Comentarios (3)

  • PRO
    Mystic Pools, LLC
    hace 6 años

    Power to the SWG should come off the load side of the power supply to the pump. This is for any type of circulating pump.

    Not sure the type of switches you have-time clock, computer system-Jandy RS, Pentair.... On these types, get power from the load side of the relay. Always refer to the manufacturers wiring so you understand. Consider an electrician if your not familiar.

    On a VS pump however, the SWG needs a certain flow rate for it to work properly. Refer to the SWG's manual for that. Adjust the pump's flow rate accordingly. Some SWG's have flow switches to activate them.

  • PRO
    Precision Pool Construction
    hace 6 años

    The salt generator has a power cwnter that controls it. It uses the flow sensors to only run when it has flow. So not sure why that is necessary ?

  • PRO
    Mystic Pools, LLC
    hace 6 años

    That's correct, the SWG has it's own power system. It can only function though when it is given proper water flow. The owner's manual should have that required flow rate listed. A VSP may have to be adjusted to activate the flow sensors on any SWG for them to work.

    If a cell was powered continuously even when the pump was off, it would eventually damage the cell. There's no sense in relying completely on a SWG flow switch or sensor to turn the cell on or off. Sensors and flow switches will fail at some point. That is why the SWG should get it's power source from the load side to a filter pump to prevent any damage. This is for any pump type.

    A dirty filter will cut water flow and not allow a SWG to be activated. Same holds true for a pool heater. It has a pressure switch that only gets activated upon water flow.

    For our electronic auto fill devices, those too are powered off the load side to a pump. Pressure side cleaners with a separate booster pump also.

Patrocinado

Volver a cargar la página para no volver a ver este anuncio en concreto

España
Personalizar mi experiencia con el uso de cookies

Houzz utiliza cookies y tecnologías similares para personalizar mi experiencia, ofrecerme contenido relevante y mejorar los productos y servicios de Houzz. Al hacer clic en 'Aceptar' confirmo que estoy de acuerdo con lo antes expuesto, como se describe con más detalle en la Política de cookies de Houzz. Puedo rechazar las cookies no esenciales haciendo clic en 'Gestionar preferencias'.